D6rpf-5 @@@SOLD@@@

[J. Hoover]

M&P or tactical blade done in Kirinite and CPM3v. It feels great in the hand and is scary sharp. Scales on this one were attached using stainless 3/16 standoffs and stainless 4-40 machine screws. I also epoxied them so they are permantly attached. Kydex sheath is set up for your tek-lok. Here are the specs:

Steel- CPM 3v X 3/16
AOL- 10 1/4 inches
HT- In house to a RC of 59-60
Blade- 5 1/4 inches to front of scales with finger choil for precision when required and a skull crusher on the tang for when it's not.
Grind- Flat with drawn unsharpened swedge and thumb jimping on the spine ( scary sharp)
Finish- Hand sanded to 2000 grit then etched for a subdued finish.
Handle- 5 inches
Scales- Desert Camo Kirinite
Hardware- Stainless 3/16 standoffs with stainless 4-40 Torx screws
Sheath- .80 Kydex in Urban Camo set up for YOUR large Tek-lok- Multiple carry options, right or left hand, vertical, horizontal, or handle down. Knife clicks into sheath for a secure carry.
Asking 225.00 shipped in the USA or Canada
Paypal, USPS M/O, or Certified Check preferred. Email for other options
Questions or comments welcomed
Thanks for looking
If your interested post an I'll Take It in the post

 

[gregorio]

Cool handle material on that one, I don't think I have seen that before.

 

[Jonathan T]

That is absolutely beautiful. Very nice work.

 

[Flatsman007]

That sure is slick!!

 

[Idlewild]

Terrific profile on this one Joseph...blade and handle. Very nice!!

 

[J. Hoover]

Thanks guys, I do appreciate the kind words.
If your looking for a tough sharp working blade this one can stand the test.

 

[theHobbyist]

Great now I'm going to toss my new scale material... lol no kidding I just ordered some like that... Looks GREAT!

 

[J. Hoover]

Hey Hobby, you'll like it. It works nice but is some seriously tough stuff.

 

[planewinch]

nice work Joe, very nice. this one is an original!
Steve

 

[J. Hoover]

Hey Steve, long time my friend. Good to hear from you. Thanks for the kind word.

 

[J. Hoover]

This one needs a home fellows so I'm reducing it, now 225.00 shipped in the USA or Canada.
If your unfamiliar with CPM3v it's one of the better high carbon steels available if your looking for toughness and edge holding. It's also more expensive to make as the heat treat alone takes 8 hours to do correctly. Don't even get into how it eats sanding belts and sand paper when hand sanding.

 

[Jonathan T]

Price drop and my paycheck could not have been more conveniently timed. I'll take it. Will send you an email.

 

[J. Hoover]

It's yours Jonathan, thanks. I responded to your email.