G L Drew
Knifemaker / Craftsman / Service Provider
- Joined
- Feb 3, 2005
- Messages
- 4,791
I forged a billet of 15N20 and 1084 high carbon steel to create this knife
It was heat treated in my Evenheat furnace with three normalizing and two tempering cycles to Rc 58-60 with a fine grain structure throughout the blade.
Flat grind (the clip is not sharpened)
The guard is made from a very grainy piece of wrought iron
Desert ironwood handle
Overall length: 13 1/4 inches
Blade: 7 1/2 inches
Leather sheath for a right hand carry with a belt loop large enough for a gun belts
$490 delivered within the US. I will ship outside the US with actual mailing cost applied. My PayPal and email address is gldrewknives@gmail.com
IMG_3756 by Gerald Drew, on Flickr
IMG_3755 by Gerald Drew, on Flickr
IMG_3872 by Gerald Drew, on Flickr
IMG_3754 by Gerald Drew, on Flickr
It was heat treated in my Evenheat furnace with three normalizing and two tempering cycles to Rc 58-60 with a fine grain structure throughout the blade.
Flat grind (the clip is not sharpened)
The guard is made from a very grainy piece of wrought iron
Desert ironwood handle
Overall length: 13 1/4 inches
Blade: 7 1/2 inches
Leather sheath for a right hand carry with a belt loop large enough for a gun belts
$490 delivered within the US. I will ship outside the US with actual mailing cost applied. My PayPal and email address is gldrewknives@gmail.com
IMG_3756 by Gerald Drew, on FlickrIMG_3755 by Gerald Drew, on FlickrIMG_3872 by Gerald Drew, on Flickr
IMG_3754 by Gerald Drew, on Flickr
Last edited:
