Made this one using Alabama Damascus, 52100, 5160, 203e, and 15n20 for 416 layers. Deep etch for a nice strong pattern in the damascus. Scales are stabilized Redwood Burl with 6 nickel pins and 1/4 brass lanyard tube. The sheath was hand sewn and fitted for this knife. It's fully tooled and finished out. Unfortunately for me when I was shaping the scales I notice a hairline crack in the left scale. It does not run the full width of the scale, and since the scale is epoxied I don't think it will ever be a problem. I did apply some super thin ZAP crack repair so unless you really look for it you probabbly would not know its there. Anyway my misfortune is your good fortune because I'm letting it go as is at a reduced price. Here are the specs:
Steel- Alabana Damascus X .145
AOL- 9 3/8 inches
HT- In house
Grind- Flat modified scandi grind with jimping on spine ( Shaving Sharp)
Blade- 4 5/8 inches
Handle- 4 5/8 inches with contoured double palm swells
Scales- Stabilized Redwood Burl
Hardware- Six 1/16 nickel pins and 1/4 inch brass lanyard tube
Sheath- RH pouch style. Made for and fitted to this knife, it was handsewn, fully tooled and finished out
Regular price- 300.00
Asking 210.00 shipped in the USA
Paypal, Certified Check, or USPS M/O preferred
Questions or comments welcomed
Thanks for looking
Post and I'll Take It if you want it.
Steel- Alabana Damascus X .145
AOL- 9 3/8 inches
HT- In house
Grind- Flat modified scandi grind with jimping on spine ( Shaving Sharp)
Blade- 4 5/8 inches
Handle- 4 5/8 inches with contoured double palm swells
Scales- Stabilized Redwood Burl
Hardware- Six 1/16 nickel pins and 1/4 inch brass lanyard tube
Sheath- RH pouch style. Made for and fitted to this knife, it was handsewn, fully tooled and finished out
Regular price- 300.00
Asking 210.00 shipped in the USA
Paypal, Certified Check, or USPS M/O preferred
Questions or comments welcomed
Thanks for looking
Post and I'll Take It if you want it.
Last edited:
