Dang i stripped out my pocket clip screws

[SladeGT40]

and i've had screws come that only took 2 days from first contact to my doorstep ......(ill let you ponder that one )

 

[SPXTrader]

and i've had screws come that only took 2 days from first contact to my doorstep ......(ill let you ponder that one )

Escort service busy that weekend?

 

[SladeGT40]

Escort service busy that weekend?

i was going more for the elusive marathon session sir? remember your youth

 

[Bfusmc03117]

i have not even got a response form kershaw and its been almost a week. Any opinions

 

[spiralarchitect]

call them

800-325-2891

 

[Cotherion]

T6 is too small for a knife such like this. I replaced mine with T9 and I will never have to worry about stripping the T6 screws.

I personally feel that Kershaw should try to use less of the T6 or T7 screws cause incidences of screw head stripping is all to common for these sizes.

Sure someone will say you used the wrong tools, or you put too much pressure, or maybe even you torx drivers are worn. But definitely a change from T6 to maybe T8 for the ZT300 series would be a welcome change.

 

[SPXTrader]

The OP said he used the wrong tool. An allen wrench instead of a torx bit. It's all in having the right tool for the job.

 

[PG5768]

and i've had screws come that only took 2 days from first contact to my doorstep ......(ill let you ponder that one )

You must have been awfully sore afterward.

 

[SladeGT40]

not as much as .......well

 

[Desert Heat]

i have not even got a response form kershaw and its been almost a week. Any opinions

This is a first. However, there can be many explanations for this.
Hey, I know….. Call them. I hope this has not been said before. I hate repetition.

 

[Bfusmc03117]

Kershaw is great right when i was about to call them today i got the mail and there they were my screws and pocket clip no questions, surveys or any junk in order to get parts. Awesome response and deliverytime Kershaw