Davison Custom Knife

T.A.DAVISON

Slip Joint Knife Maker
Feedback: +106 / =0 / -0
Joined
Oct 24, 2005
Messages
5,477


Folder - #1605

~~~$600.00~~~



Sold - Thanks



1605AAA.jpg





Scales - Jig Bone
Steel - 3/32'' - CPM154 - Rc. 61
Bolsters & Liners - stainless, coined edge.

Shield - stainless - inlaid & dbl. pinned

Closed - 4''

Hollow Ground, Hand Finish, Cryogenic Quenched
Half Stop, Very nice walk & talk, Razor Sharp!
.....Closes dead center.
Shipped in a protective case.


You can say I'll take it here.
Pay Pal is preferred.
Out side USA shipping is extra.

Any questions or comments are welcomed.
Thanks for the looks.







.
 
Last edited:
Todd, I recently bought this knife from a fellow blades forum member. However upon receiving it I have noticed it has some blade play. Is this something I can fix myself ? If so how would you recommend that go about it .

Regards, Nik
 
Todd, I recently bought this knife from a fellow blades forum member. However upon receiving it I have noticed it has some blade play. Is this something I can fix myself ? If so how would you recommend that go about it .

Regards, Nik
I don't think Todd will see your message here. He used to sell a lot of stuff here, but I don't know how often he comes around any more. Your best bet would be through Instagram or here:


Good luck!
 
I don't think Todd will see your message here. He used to sell a lot of stuff here, but I don't know how often he comes around any more. Your best bet would be through Instagram or here:


Good luck!
Thanks for the heads up Chris, I’ll try instagram
 
Back
Top