- Joined
- Jun 6, 2012
- Messages
- 783
Hey guys, hope everyone is doing well. It's the start of my spring break, so I decided it would be a good time to post a knife. :thumbup: Here is one of my new designs for a cool little fixed blade for edc.
Asking $155 shipped inside the US for this one.
Specs:
OAL-6 1/2"
Blage Length-2 7/8"
Steel- .19" CPM 3v heat treated to 61hrc by Peters Heat Treating
Handle Material-Green canvas micarta with a natural micarta pin and tube
Sheath-Leather pocket sheath made by my dad.
These pictures were shot outside, so please excuse some of the funny reflections on the grind, I'm new to doing the outdoor photos.







Thanks for looking, any comments are appreciated, I would like to hear what you think!:thumbup:
Asking $155 shipped inside the US for this one.
Specs:
OAL-6 1/2"
Blage Length-2 7/8"
Steel- .19" CPM 3v heat treated to 61hrc by Peters Heat Treating
Handle Material-Green canvas micarta with a natural micarta pin and tube
Sheath-Leather pocket sheath made by my dad.
These pictures were shot outside, so please excuse some of the funny reflections on the grind, I'm new to doing the outdoor photos.







Thanks for looking, any comments are appreciated, I would like to hear what you think!:thumbup: