Did BUCK ever,,,,,

[Mitch W.]

Make a 110 and/or a 112 with a partially serrated blade? Not including customs that is.

 

[2TONYB]

Yes. I know of a buckcote model. Not sure of others.

 

[2TONYB]

 

[Larry Oden]

Yes, on 110s for sure. Both long and short partially serrated versions, circa 1989, give or take. The short versions were about an inch or inch and a quarter long. The long versions were probably another one quarter to one half inch longer. Then other partially serrated versions on other special projects were also done from time to time in subsequent years. I think at least one was done for Herbertz but that was not the only one. I am just giving a quick reply based upon memory and without looking at my documentation.
As to 112s, I cannot recall any off the top of my head but they could exist.

 

[Badhammer]

IIRC I got one off the web specials earlier this year or late last year. It's a 110 with ATS34, partially serrated blade.

It was last June. My does time fly or what?

http://www.bladeforums.com/forums/s...k-serration-variations?highlight=web+specials

 

[bertl]

I have a 4 Dot finger groove 110 with a partially serrated blade. I think the serration is about 1 1/4".

 

[David Martin]

During 90-93 Buck made a ton of partially serrated blades for their V52 Selector, a clip blade. If this counts. The exception is the drop point blade which was done fully serrated. Nice photo Tony. DM

 

[Richard Matheny]

All serrated 110 and 112 models were limited editions and not production offerings if that is what is being asked.

 

[bucksway]

The 450 blade that is used in a very few 112's came in a serrated version..But except for the 2 Custom Shop 112's that I ordered with serrations I have never seen a 112 with them..****SOMEWHERE***** I bet there is,most likely a employee or service award knife..Because of this thread I bet we will see one show up.RRR is READY!!