EDC/BNT in ironwood (sold)

A

Alan Warren Knives

Feedback: +62 / =0 / -0
Joined
Dec 31, 2009
Messages
2,630
Hello to all, Just finished this cool little one. It is finely finished and made to be used. Hope you like it.

Blade is CPM 154 .104 thick and 3.2 tip to bolsters. O/A is 7.45. Heat treated with cryo and double tempered. I polish the blade then hand finish with 2000 grit. VERY sharp. Tang is tapered and hollow ground so the epoxy has a place to stay.

Bolsters are 416 stainless held tight with .092 pins.

Handle is ironwood burl with stainless pins, thin red liners and lanyard with hand made bead.

Sheath is hand tooled, hand stitched 8-9 ounce leather. I use the Loveless cam idea so the knife fits very nice and secure yet is easy to withdraw.

Asking (sold) shipped in the USA. My paypal is warren customknives@yahoo.com Thank you all for looking. Alan
 

Attachments

  • P1013757.JPG
    P1013757.JPG
    422.2 KB · Views: 291
  • P1013749.JPG
    P1013749.JPG
    565.1 KB · Views: 301
  • P1013750.JPG
    P1013750.JPG
    464.7 KB · Views: 284
  • P1013751.JPG
    P1013751.JPG
    385.8 KB · Views: 280
  • P1013752.JPG
    P1013752.JPG
    457.2 KB · Views: 271
  • P1013753.JPG
    P1013753.JPG
    425.2 KB · Views: 275
  • P1013754.JPG
    P1013754.JPG
    434.2 KB · Views: 273
  • P1013755.JPG
    P1013755.JPG
    447.1 KB · Views: 275
  • P1013756.JPG
    P1013756.JPG
    433.4 KB · Views: 272
Last edited:
Alan,
QUALITY and BEAUTY X TEN.
I own 5 of Alan's knives and my friend has 1, they look
really nice in the photos, THEY ARE FANTASTIC IN HAND.
 
Alan...a man of vision...thanx for coming up with a blade thickness and blade-length that isn't intended for disecting a rhino.
It's a gorgeous knife; great blade-steel, and a very useable design.
Pleased to see your work...
Don
 
Great looking package Alan - super nice taper on the tang :thumbsup:
 
Once again a gorgeous knife and sheath. :thumbsup:
 
Last edited:
Beautiful knife Alan. I would take it if still available. I'll check back later this morning.

Andy
 
Last edited:
You must log in or register to reply here.
Back
Top