1/8" AebL
Hollow Ground
Cutting edge is about 3 1/8"
OAL is 7 1/8".
Handled in Paduak with Lime Green G10 liners & Brass Corby screws.
Handles were slightly sculpted for a nice high, tight grip. Also works well with a 3 finger grip.
Slight gap on the top of one handle side by the makers mark. Slightly noticeable. But with the corbys & epoxy, these handles aren't going anywhere.
Asking SOLD shipped to the 50 states. Price includes leather pocket sheath. Sheath is currently being made, but if you ALSO want a carbon fiber holstex sheath for edc, I can make one for $10 extra.
First I'll take it, its yours.
Paypal to sarabonifas@yahoo.com
Contact me at colu41 @ gmail
If purchased by tomorrow afternoon, both with ship by Friday afternoon.
1/8" AebL
Flat Ground
3 1/2" Cutting Edge
Just over 8 1/2" OAL
Brass guard, with brass, black g10 & deer antler spacers. With stabilized redwood burl to top it off.
Theres a few nicks, and spots on the guard. Mostly underneath, but a few on top. Hardly noticeable. But had to mention. Hidden tangs are definitely new to me. A bit different process than full tang.
Everything is epoxied and finally pinned with brass pin.
Asking SOLD to the 50 States. Will come with leather sheath.
Hollow Ground
Cutting edge is about 3 1/8"
OAL is 7 1/8".
Handled in Paduak with Lime Green G10 liners & Brass Corby screws.
Handles were slightly sculpted for a nice high, tight grip. Also works well with a 3 finger grip.
Slight gap on the top of one handle side by the makers mark. Slightly noticeable. But with the corbys & epoxy, these handles aren't going anywhere.
Asking SOLD shipped to the 50 states. Price includes leather pocket sheath. Sheath is currently being made, but if you ALSO want a carbon fiber holstex sheath for edc, I can make one for $10 extra.
First I'll take it, its yours.
Paypal to sarabonifas@yahoo.com
Contact me at colu41 @ gmail
If purchased by tomorrow afternoon, both with ship by Friday afternoon.
1/8" AebL
Flat Ground
3 1/2" Cutting Edge
Just over 8 1/2" OAL
Brass guard, with brass, black g10 & deer antler spacers. With stabilized redwood burl to top it off.
Theres a few nicks, and spots on the guard. Mostly underneath, but a few on top. Hardly noticeable. But had to mention. Hidden tangs are definitely new to me. A bit different process than full tang.
Everything is epoxied and finally pinned with brass pin.
Asking SOLD to the 50 States. Will come with leather sheath.
Last edited:
