EDC in 1095 and natural canvas micarta with horizontal carry sheath..

[Wolf Creek Forge]

Here is a nice EDC made from Aldos 1/8" thick 1095. The knife is 6 1/4" long voerall with a 2 3/4" cutting edge..Flat ground and very sharp..Digitally controlled heat treat, two temper cycles and parks 50 quench..The handles are natural canvas micarta with one black micarta pin and a 5/16" stainless flared lanyard tube..The sheath is hand sewn from 8oz leather made for horizontal carry..Will work right or left handed..Good snug fit :thumbup:..
Im asking $109 shipped priority for this knife and sheath..I take paypal and money orders..My paypal is wolfcreekforge@bellsouth.net
Thanks and the first "Ill take it" gets it..

 

[TrojanTau]

great looking knife Lisa!

 

[Wolf Creek Forge]

Thanks very much..Its a handy knife..you know, kinda feels and cuts bigger than it is..If that makes sense

 

[Leethal Cutlery]

I love natural micarta. Good lookin little knife!

 

[Leethal Cutlery]

Also do u hot stamp? Or stamp before heat treat while cold? You get good definition on your stamp. I have to whack mine a couple times to get a deep impression.

 

[Wolf Creek Forge]

Hot stamp, before we do the stress relief cycles..Then heat treat..

 

[combs6136]

I like the knife, but i love the sheath.......carl

 

[Wolf Creek Forge]

I like the knife, but i love the sheath.......carl

Thanks..I appreciate it..:thumbup:

 

[lacticacid]

Good looking package. I'll take it.

 

[Wolf Creek Forge]

Good looking package. I'll take it.

Thank you, its yours..Please let me know if you need any other info..Ill have it ready to ship..

 

[Tilley Knife]

A day late and a dollar short. That's a great looking setup Lisa. I hope to see one of these offered again. Best regards - WB