I made this knife as an all-around EDC knife. The blade is CPM S30V, heat treated by Paul Boss to 60HRC. He does the amasing treating. It is about 4-1/2" long, 1" wide and 1/8 thick at the bolster. Flat ground and sandblasted for nice satin finish.
The bolster is mokume-gane, my make. It is nickel-silver-copper mixture. The handle is the amazing curly maple with wild figure. The blade's tand goes all the way through and has the internal nut covered with the mokume button.
The sheath is 9Oz leather, hand stiched, dyed and treated with carnauba wax.
The knife is sharp and ready to go.
I am asking $250 for it shipped via Insured Priority Mail.
SOLD, pending funds.
Pay Pal preferred, but I will accept the personal check(will ship after the check is cleared).
The bolster is mokume-gane, my make. It is nickel-silver-copper mixture. The handle is the amazing curly maple with wild figure. The blade's tand goes all the way through and has the internal nut covered with the mokume button.
The sheath is 9Oz leather, hand stiched, dyed and treated with carnauba wax.
The knife is sharp and ready to go.
I am asking $250 for it shipped via Insured Priority Mail.
SOLD, pending funds.
Pay Pal preferred, but I will accept the personal check(will ship after the check is cleared).
Last edited:
