EDC (Sold)

[KHall]

Here is an EDC Knife. This blade was differentially heat treated (clay coated spine) and tempered to a Rockwell hardness of around 60. To keep production cost down I did not polish out the Hamon line, but only hand sanded the blade to 220 grit.

Steel – W2
Knife dimensions:
Overall length – 8 1/8 inches
Blade length – 4 inches
Blade width – 1 1/4 inches
Handle – Micarta
Pin – Brass Corby Bolts

Price - $180

I will ship international, but buyer pays the additional cost.

PayPal and email khall@hallenergyconsulting.com

Regards,
Ken

 

[timos-]

sweet knife! I would think that would be pretty nice bush craft type blade too. You didnt mention the thickness at the spine or behind the edge.

 

[KHall]

Timos,

The thickness at the spine is 0.163 inches, behind the cutting edge is 0.02 inches.

Ken

 

[blademan11]

I'll take it. PP on its way.
blademan011@att.net

 

[KHall]

Blademan11, it is yours.
Ken