Jack O'Neill
Gold Member
- Joined
- Nov 15, 2007
- Messages
- 7,176
I outfitted this edc wharnie in Sambar Stag . I left the stag a little wide in order to keep the bark ( a pic shows it ) and it fits the hand well and is very comfortable . If a customer would like it thinner and lose some of the bark , I will be happy to do so .
SOLD
Steel- 5/32" ATS-34 S.S . Heat treat to an Rc. 60-61
O.A.L- is 6-3/4"
Blade - is 3" and sharpened edge is 2-3/4"
Width- is 7/8"
Grind - flat ground with a scothchBright satin finish
Handle - Sambar Stag , red liners , mosaic & brass pins
Sheath- Tooled Herman Oak , 7 oz , made by Ray Simmons . Right or Left hand carry .
$150.00 + $10.00 for USPS shipping in the USA & Canada . International a bit more . Pay-Pal sugarland@wwest.net or postal M/O , check will be held for clearance .
Thank you all , and as usual , comments welcomed . Good I hope .
View attachment 232645View attachment 232646View attachment 232647View attachment 232648View attachment 232649
SOLD
Steel- 5/32" ATS-34 S.S . Heat treat to an Rc. 60-61
O.A.L- is 6-3/4"
Blade - is 3" and sharpened edge is 2-3/4"
Width- is 7/8"
Grind - flat ground with a scothchBright satin finish
Handle - Sambar Stag , red liners , mosaic & brass pins
Sheath- Tooled Herman Oak , 7 oz , made by Ray Simmons . Right or Left hand carry .
$150.00 + $10.00 for USPS shipping in the USA & Canada . International a bit more . Pay-Pal sugarland@wwest.net or postal M/O , check will be held for clearance .
Thank you all , and as usual , comments welcomed . Good I hope .
View attachment 232645View attachment 232646View attachment 232647View attachment 232648View attachment 232649
Last edited: