Elk Horn Lockback Folder

nighthaxan · Dec 27, 2013

Well, this one is a toughy for me. I'm offering up my first lockback that I've made, so be warned, it's not perfect. The blade is 2 1/2" long by 1/2" wide and 3/32" thick Flat ground 154 CM stainless, Heat Treated by TKS to RC 59-60. Bolsters are textured Nickel Silver with Elk Horn bringing the OAL to 6"s, closed 3 3/8". Asking $225, includes slip case and shipping in CONUS.

Thanks for looking, Charles

Jay_Wyatt · Dec 27, 2013

That's an awesome knife!

Eliot · Dec 28, 2013

Looks pretty good for your first attempt at a lockback!

nighthaxan · Dec 28, 2013

Eliot said:
Looks pretty good for your first attempt at a lockback!

Thanks Eliot, I find I'm my own worst critic on knives I've made, the internals on this didn't seem hard until I got into fitting them up.

RecalcitrantAmerican · Dec 28, 2013

Wow, that is very impressive work for a first time lockback. You should be very proud of your product sir. The Elk Horn with the textured nickel bolster was a wise decision. It really is a pretty lil knife. Thank you for showing the innards.

Mr. Eliot, you sir are producing some fabulous pieces as well.

doc trinidad · Dec 29, 2013

that's a pretty little thing very tempted but to close to Christmas!

Shing1287 · Dec 30, 2013

I've always wanted to try one of those Rough Rider kits like that. Wouldnt wanna start from scratch though.
http://www.knifesupply.com/eshop/10Expand.asp?ProductCode=RRCS5

nighthaxan · Dec 30, 2013

Shing1287 said:
I've always wanted to try one of those Rough Rider kits like that. Wouldnt wanna start from scratch though.
http://www.knifesupply.com/eshop/10Expand.asp?ProductCode=RRCS5

Hell, if I'd known they made a kit, I'd have done that first to save myself some hours.