ENDED - MagnaCut EDC Wharncliffe and Utility Knife

David Mary

pass the mustard - after you cut it
Moderator
Knifemaker / Craftsman / Service Provider
Feedback: +136 / =0 / -0
Joined
Jul 23, 2015
Messages
18,962
Utility Knife:

Steel: 1/8" CPM MagnaCut, 60-61 (expert heat treatment by Jarod Todd)

Geometry: Full flat-vex, zero ground with small microbevel.

Overall Length: 8 1/8"
Edge length: 3 3/4"

Weight: 4.8 oz

Handle: OD green canvas Micarta, brass pin and tube

Sheath: Black Boltaron included, taco by default


SOLD


IMG_2949.JPG
IMG_2950.JPG
IMG_2955.JPG


EDC Wharncliffe:

Steel: 3/16" CPM MagnaCut, 60-61 (expert heat treatment by Jarod Todd)

Geometry: full flat, zero ground with small microbevel

Overall Length: 6 5/8"
Edge length: 2 3/4"

Weight: 4.5 oz

Handle: Black G10, green and charcoal grey laminate wood (Frogblanks*), yellow G10 liners, brass pin and tube

* Per the manufacturer, there is a mild formaldehyde based water soluble chemical in this material that can leech out, and if you eat it you will have an upset tummy, but you should be able to shake it off. ;) Just keep it oiled to prevent said leeching.

Sheath: Black Boltaron included, taco by default, or pancake add $7.

Bit of a visible glue line between G10 and wood. You can catch it with your fingernail, but does not affect function or ergos. Cosmetic blem only, but price reduced accordingly.

Withdrawn

Thanks for looking!

IMG_2945.JPG
IMG_2946.JPG
IMG_2947.JPG

In case interested, here is a post from a prior customer expressing his thought on MagnaCut knives I made him:
 
Last edited:
Wharncliffe is withdrawn.

Utility is still available. Here is a pic of it in the dry:

IMG_2966.JPG
 
Back
Top