Engraved knife in CPM S30V and Cocobolo.

D

Dmitry.M

Feedback: +43 / =0 / -0
Joined
Jun 13, 2006
Messages
1,008
The blade is 4-3/4+ long, 3/16" thick at the bolster and a tad less than 1-1/2" wide. Taper to the tip. HT by Paul Bos, 60HRC. Flat ground, hand finished to 800grit.
The scales are cocobolo. 1/8" 416 Stainless Steel pins. The bolster is 416 Stainless Steel. Dovetailed and pinned.
I hand engraved the bolster with my own One-Of-A-Kind design. The background is recessed and stippled. The leaves are shaded. There is no paint or dye in the engraving. Just a touch of a Gun-Blue. The scale pins are engraved as well.

The sheath is hand stitched from 7-8oz leather. I tooled in the style that matches the bolster engraving. Sheath back side is smooth. The leather is treated with saddle oil and slightly polished. Belt loop should take up to 2-1/4" wide belt.

I ask $495 for it shipped CONUS. PayPal preferred (dmalakhov@hi.umn.edu)
I will accept Post Money, MO or Personal Check(will ship after the Personal Check is cleared).
Thank you.
 
Very nice piece, Dmitry! Engraving looks crisp, nice Cocoabolo and sheath matches very well! I like it!!
 
That looks great! The engraving is top notch and blends in perfect with the blade and scales. A classic combo IMO.
 
I have a knife by Dmitry from this same steel. Boy am I pleased, very good, holds the edge very well. This knife is beautiful.
 
Very nice!
How long is the handle & do you put a makers mark on your knives. I don't see one.
 
Mick57!
The handle is 4-1/2" long. The mark in engraved in micro letters on the right side of the bolster. It is my logo\makers mark and year(2011).
Thank you.
 
Very good job is done for this knife, and as a hunter I was really amased by that CPM S30V big skinner with Paul Bos heat treatment in your another thread.:thumbup:
Очень впечатлил тот скиннер.
 
You must log in or register to reply here.
Back
Top