ESEE 4 cross draw

[Frontiersman101]

I orderd my ESEE 4 and it shipped today. Is there any way to set up the stock sheath for cross draw? Or do I have to get one made? Thanks

 

[Hodaka]

I got mine with the MOLLE back, and it works fine. Just run your belt through the MOLLE loops, most belt widths will work.

 

[Frontiersman101]

Does it have a tilt?

 

[malada]

I wear mine crossdraw like this all the time.

 

[Hodaka]

Does it have a tilt?

Slight tilt - depends on belt width. I can't see the way malada carries his working for me - I'd be getting jabbed bad by the handle every time I bent over. But then, I've got a bit more of a middle than him.

 

[adaman04]

I wear mine crossdraw like this all the time.

Ahhh, the wonders of the paracord belt loop system.

 

[gdeno]

if you want to spend a little more, or if you already have one, using a tek-lok works great for this application. Basically you mount it just as you would for right side draw but place it on your left. simple fix. I usually mount the lok upside down because it is easier to get on and off but to each their own. hope this helps.

 

[Dizwolf]

I took a boot clip for an esee3 and mounted it on the esee4's sheath. This works very very well for pocket, iwb on my back right side, or iwb cross draw. Hides the knife well, but easy to access. I've been carrying mine like this for a couple weeks now. It carries well in public, but I'm still getting used to breaking out a blade that large. I may go back to the three, but I'm going to give it a few more weeks.