EvenHeat Oven Set Pro vs RampMaster?

[Kentucky]

Well, we are about 3/4 of the way to ordering a new heat treat oven Leaning towards a 18" Evenheat with the rampmaster..I have searched but it seems no one has really explained the differences between the set pro and the rampmaster controls..Can anyone give me a quick lowdown of the major differences? Thanks

 

[Brian Avila]

When I was looking at the 18" Even Heat ovens the ramp master allowed for 10 programs compared to the set pro only allowing 4. If you go the the www.usaknifemaker.com and look at the Even Heat section they have some good info.

Here is a link to info and a little video that talks about the set pro:

http://usaknifemaker.com/heat-treat-ovens-and-accessories-c-57/evenheat-ovens-and-kilns-c-57-81/using-the-set-pro-controller-example.html

 

[silver_pilate]

Also, setup is a lot easier with the Rampmaster since you have a full numberpad.

--nathan

 

[Kentucky]

Thanks a bunch guys.

 

[Brett Mathews]

Rampmaster is nice but is allot more $. Before my shop burned down I had the Rampmaster and still ended up putting the HT program in each time as I could never remember which one of the ten was which. When I get a new one it will the Set pro

Brett

 

[Karl B. Andersen]

You really don't need anything more than the set-pro. And make sure you get the 22 1/2".

 

[nthe10ring]

Several demos on You Tube on both units. Search Evenheat.

Jerry