Evil Twin

[harlen.shaw]

Looking for feedback on the new knife. Thanks guys.

shaw-shanks.com

 

[festerfromnzed]

Nice lines....a few details about, steel,heat treat, dimensions etc....would be good!.....FES

 

[harlen.shaw]

11.9" OAL
6.7" Blade length
2.1" Blade width
1/4" Thick
5160 Spring steel
58HRC
Black G10 handle Scales
Full convex grind

You mentioned you'd like for the blade to go all the way to the guard; I can make one without the small choil for you if you're be interested in it.

 

[Veesix]

Nice more pics?

 

[Rapt_up]

Looks pretty nice, but I'm a sucker for recurve and I agree more pics!

 

[Jack O'Neill]

this is the for sale section , not the feedback section

 

[RevDevil]

this is the for sale section , not the feedback section

You are correct Jack. I moved it over to Feedback.

 

[harlen.shaw]

Ok, well looks I finally found the right place. First put it in the general discussion, then everyone said knifemaker for sale section, now I'm in the feeback section. :indecisiveness:

 

[harlen.shaw]

Heres some more pictures.

 

[RevDevil]

Ok, well looks I finally found the right place. First put it in the general discussion, then everyone said knifemaker for sale section, now I'm in the feeback section. :indecisiveness:

No worries sir, this is a huge place.

 

[Jack O'Neill]

I really expected to see this moved to shop talk in the knife makers discussion section ( I guess where you were to begin with ) not the GBU .

 

[RevDevil]

If you all are up for a road trip, I can move it there too. I wasn't really sure. Just say the word and we'll buckle up and truck on over to the Shoptalk area.

 

[harlen.shaw]

Next stop Shoptalk! nthego:

 

[crimsonfalcon07]

Has a bit of a Bussekin look to it. I'm told that drilling holes in the front guard is patented, so you might need to rethink that design feature. Other than that, it looks good to me. I like the finish a lot.

 

[harlen.shaw]

Thanks for the heads up. I looked into it and sent Jerry an email, never saw his knives before this, if there's an issue I'll change it. This one as well as another was drawn up by a buddy of mine so I guess I now know where his inspiration came from. I'm not trying to copy anyone elses designs. Guess I never thought about researching hole placements in a knife would be something I needed do before drilling.