Exclusive Integral damast hunter

Stefan Albert

Stefan Albert

Knifemaker / Craftsman / Service Provider
Feedback: +0 / =0 / -0
Joined
Dec 28, 2008
Messages
995
Exclusive Integral damast hunter
Exclusive Integral damast hunter
Typ of knife - Integral hunter knife
Blade - Carbon damast
Hardness - 57-59 Hrc
Lenght - 125 mm
Handle - Stabilized maple
Totall Lenght - 260 mm
Accessories and decoration - Full hand carved black Walnut box.

Price- 1 100 Usd.-

P4030192.JPG


P4030193.JPG


P4030194.JPG


P4030195.JPG



PayPal or bank transfer is ok I send knife for Fedex

Thank You

Stefan
 
That's "over the top" nice! Can you post a picture showing the handle & spine from the top?
 
Thank you Stefan. OK, after seeing this picture, it appears the handle is one solid piece. No? If that is the case, how do you fit it to the knife? It doesn't look like it will slide over either end. Logic tells me it must be 2 pieces, but I don't see a seam down the middle.
Maybe I need another cup of coffee to figure it out. :)
 
Last edited:
Yes, the handle is one piece ,The screws holding the handle of a knife and the rear end is inserted into a separate .And sory my bad english mate .

Stefan
 
That's OK, no need to apologize.
I think what you're trying to say, the butt is a separate cap that goes on last & screws lock it & the handle in place? Is that correct?
 
That is one of my favorite knives of yours that I have seen.

Stefan Albert said:
Yes, the handle is one piece ,The screws holding the handle of a knife and the rear end is inserted into a separate .And sory my bad english mate .

Stefan
Click to expand...

Your so-called "bad english" is about 1000 times better than my best Slovak.

Again, congrats on a very fine knife.
 
You must log in or register to reply here.
Back
Top