who does the heat treat for the production blades for fiddleback forge. And what is the Rockwell for s35vn? Looking at a production bushfinger, but no Rockwell hardness is listed.
I can first hand say the steel and HT are freaking awesome. I had a very hard spot when batoning a 2x4, got stuck and kept going. it literally bent a piece of the middle edge out close to 1/8" and was 1/4" tall. I lightly hammered it back straight on the vise anvil, stone it and you can't even tell it happend. Thats good stuff.
Thank you, I went ahead and ordered one from KSF. They seem to be a little scarece and aren't listed on the FF website anymore. Have had my eye on one for awhile.
Thank you, I went ahead and ordered one from KSF. They seem to be a little scarece and aren't listed on the FF website anymore. Have had my eye on one for awhile.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.