With some big expenses coming up, I have to let a few go. These have all been used but not abused. Not looking for trades right now.
First up is a JK Knives Kephart. 8 1/2" oal, 4 1/4" blade, 1/8" thick. Tiger stripe maple scales. I believe it is O1 steel but I might be mistaken. Very classic model with serial number 3. This one has been modified by me to have a thumb groove on the right side of the handle for use during a chest lever grip. Otherwise it is as new. SOLD
Next is an old Fiddleback Nessmuk. This is one of his early Nessmuks. No maker's mark and no bullseye lanyard hole, although it does have a G10 liner in the lanyard hole and a G10 pin through the lacewood scales (and red liners). 3/32 O1 steel on this one. This one has seen very little wood and has mostly been used in the kitchen. It has a nice convex grind with a polished edge. $110
Next is a big machete type chopper from Walter Davis. This one is 3/16 thick 1075 steel. 14 1/2" overall, 8 1/2" cutting edge. Tons of fun to use on light brush. I'd like SOLD for this.
Might have another couple to put up later, but hopefully this will be all.
It's never fun to thin out the herd. Please PM me with any questions or picture requests. All prices are OBO but I am not looking for trades right now. Thanks!
First up is a JK Knives Kephart. 8 1/2" oal, 4 1/4" blade, 1/8" thick. Tiger stripe maple scales. I believe it is O1 steel but I might be mistaken. Very classic model with serial number 3. This one has been modified by me to have a thumb groove on the right side of the handle for use during a chest lever grip. Otherwise it is as new. SOLD
Next is an old Fiddleback Nessmuk. This is one of his early Nessmuks. No maker's mark and no bullseye lanyard hole, although it does have a G10 liner in the lanyard hole and a G10 pin through the lacewood scales (and red liners). 3/32 O1 steel on this one. This one has seen very little wood and has mostly been used in the kitchen. It has a nice convex grind with a polished edge. $110
Next is a big machete type chopper from Walter Davis. This one is 3/16 thick 1075 steel. 14 1/2" overall, 8 1/2" cutting edge. Tons of fun to use on light brush. I'd like SOLD for this.
Might have another couple to put up later, but hopefully this will be all.
It's never fun to thin out the herd. Please PM me with any questions or picture requests. All prices are OBO but I am not looking for trades right now. Thanks!
Last edited:
