Field & Stream - SOLD

[Jack O'Neill]

Hello all ,I have this sweet little B&T to offer
It has a full height flat grind from 1/8" A-2 Tool Steel , Satin Finished and heat treated to an Rc 61-62 with the sub-zero quench.

O.A.L is 8" , the blade is at 3-1/4" and 1/2" wide at the plunge . The sharpened edge is at 2-7/8"
Handled in Maroon Linen Micarta with purple liners and S.S. Corby bolts . The liners are hard to see since so close in color with the micarta , shows up in the right light .
Sheath is right hand carry .

$130.00 with free shipping in the USA , International friends write me for ship cost .
Pay-pal , postal m/o or check(held to clear )

Thank you all for viewing my offerings .
Jack O'Neill

 

[cbach8tw]

This a good deal for a great companion knife.

 

[cbach8tw]

I like the A2, do you think a stainless one would be a great knife to resist corrosion, say made out of cpm154? Good handle length, four finger grip?

 

[Jack O'Neill]

I like the A2, do you think a stainless one would be a great knife to resist corrosion, say made out of cpm154? Good handle length, four finger grip?

Maybe something I should think about .

 

[cbach8tw]

I wonder if it was stainless that would be a good benefit for this type of knife. If not cpm 154, I think you have used AEBL in the past?

 

[Jack O'Neill]

I wonder if it was stainless that would be a good benefit for this type of knife. If not cpm 154, I think you have used AEBL in the past?

I have never used AEB-L as everyone says it warps just looking at it . My to go S.S. use to be ATS34 .

 

[redsquid2]

Great knife!

I have used A2, and I love how it sharpens.

 

[Jack O'Neill]

Great knife!

I have used A2, and I love how it sharpens.

Thank you sir , A-2 is a great steel .