Final edition

S

Sharpe5097

Joined
Mar 2, 2017
Messages
316
OzIL2l1.jpg


Tell me everything
 
It looks good and well made. I believe however you might encourage more sales if there was a bit more arc as a guard where the blade meets the handle.
Frank
 
I still think the handle is too short and the pins are not centered vertically. The front and back pins should be the same distance in from the ends and the middle pin centered between them. The blade looks great.
Tim
 
Much better. The pin size and placement you were stuck with from the original tang, but the reshaping was worth the slight off-placenet. In future builds, plan the spacing and handle size before cutting metal. Working form a sketch and then a cardboard or wooden template is a good way to learn.
 
tim37a said:
I still think the handle is too short and the pins are not centered vertically. The front and back pins should be the same distance in from the ends and the middle pin centered between them. The blade looks great.
Tim
Click to expand...

Ya, i was trying to salvage a bad design, so things r a little off
 
You must log in or register to reply here.
Back
Top