Firestorm "C" pattern damascus

Dan Seaver

Dan Seaver

Feedback: +6 / =0 / -0
Joined
Jun 25, 2007
Messages
898
Made from Aldo's 1084 and 15n20. Grain size reduced via heavy forging at lower temperatures but I still strongly suggest triple normalization before heat treatment. The steel is rough ground.

My firestorm "C" compared to firestorm "A"; contains 50% more layers and double the number of crushed W's. This results in a pattern that is about 300% as "dense".

firestormc10-2001.jpg


firestormc10-2005.jpg


1-4 top to bottom

1) 11"x 1.12"x .16" +/- .01 The last inch contains a low spot on each side measuring down to a minimum of .064.
$95 Sold pending payment

2) 6.75"x 1.1"x .12" +/- .01
$45 sold

3) 6.75"x 1.1"x .085 +/- .02
$33 Sold

4) 3.1"x 1"x .1 +/- .02
$17 Sold


Thanks for looking!
-Dan Seaver
 
Last edited:
Dan, #3 is all yours. As my first customer to make two orders from me you get #4 for free. :thumbup: Oh darn eh? hehehe

I'll send you a PM.
 
Dan Seaver said:
Dan, #3 is all yours. As my first customer to make two orders from me you get #4 for free. :thumbup: Oh darn eh? hehehe

I'll send you a PM.
Click to expand...

Oh, damn the luck! I guess I'll just have to make a friction folder or something with it. ;) :)
 
Ok, I need new band saw blades so bar number 1 is $90 shipped; cut to fit into a flat rate box, so no longer than 8 inches per piece.
 
Jccobb2, its all yours. Your profile wont let me send you an email. Would you please send me one with the length you want the bars cut to?

Edit- You can email me at ekibyougami1911@aim.com

Thanks!
-Dan Seaver
 
Last edited:
You must log in or register to reply here.
Back
Top