Firestorm pattern damascus

[Dan Seaver]

Up for grabs two more bars of Firestorm "A" pattern damascus. Firestorm looks boring on the outside because the pattern is on the inside of the bar. I suggest grinding over forging on firestorm to bring out the pattern.

Like always made from Aldo's 1084 and 15n20. I cut no corners when I make my damascus, I loose 75%-80% of the steel I start with though grinding and cutting off any sections that do not meet my standards. I stand behind my steel 100%.

Top bar.
12.5x1.1x.12 +/- .02 This bar contains a very small defect, 7 inches from the unetched end. A very small split caused by forging a tightly twisted billet. The split goes about 1/8" into the bar. Price reduced on account of this.

$60

Bottom bar
14x1.15x.14 +/- .02

$90

Edit, here's a pic of what the pattern looks like with a full height chisel grind.

Thanks for looking!
-Dan

 

[Dan Seaver]

Finished another bar today.

8.75"x1.28x.1 +/- .025 There are 2 small splits if found after etching caused by forging a tightly twisted bar on the very ends of the bar. The steel from the splits to the ends is not included in the price and can be easily removed when you make the tip. I will highlight the splits so you can find them.

$40

Thanks for looking
-Dan

 

[Danbo]

I'll take this last bar, please. PM sent. I'd also like the 14" piece too.

 

[leighjohn83]

Nice looking steel!

 

[69_knives]

Dan, I'll take the 12.5" bar if you'll mail it to Canada.

You can go ahead and cut it in half so there will be two ~6" pieces so it will fit in a small envelope.

Let me know about the shipping and I'll send paypal.

 

[Dan Seaver]

Thanks Leigh, I have a new bar of firestorm I'm working on and the pattern should be about 300% of what this one is.

All bars are sold pending payment. Thanks for looking everyone!