First Bushcrafter!

JK Knives

JK Knives

Moderator
Joined
Mar 6, 2001
Messages
28,227
Here is the first scandi ground Bushcrafter. It`s in orange G10, with forged finish. Normally they would only have three pins or tubes, but the customer wanted three plus a lanyard hole. This one is going to udtjim next week.

dh97kl.jpg


29xt5zt.jpg


30cyt8h.jpg




29xt5zt.jpg
 
Last edited:
Looks nice 'Ol Bud ! I think it would also look really good in tigerstripe maple with red spacers & a polished finish on the blade :thumbup:
 
Last edited:
Are those pins/tubes SS or brass? It's hard for me to tell on my crappy monitor. Do you have brass tubes?

Also, do you have or can you take a view of the handle from the top to show us the contour of the handles?

Thanks
 
Hi Stomper -

That is really sweet!

I figure on one of those or a Lobo for my next order (after the pending three are done)....

I am only doing this for my wife, since she badly needs quality custom cutlery for her kitchen. That's my story and I am sticking with it. :D:thumbup: :cool:

best regards -

mqqn
 
This one just went in the scrap bin. :mad: I went out to do a little final detail work on it this morning, slipped, and ground up the side of the blade. I`ll start over next week. Is it too early to start drinking?
 
All is not lost! After calming down and thinking, I decided to redo it as a full convex grind.

23mpngi.jpg
 
Last edited:
Great looking blade/s! Nice save. You are making my decision very freaking difficult.
 
You must log in or register to reply here.
Back
Top