- Joined
- Jun 11, 2006
- Messages
- 8,651
K, i finley got the kahonas to do a Integral that i have been putting off. i am going to mill out all the pockets and cutouts. i am getting my stock from a large block of CPM-3V 
that i have. the handle area is going to be devided into 3 sections by leaving rased spacers. each spacer, butt and guard is going to be inlayed with mother of pearl. the scales will be elephant ivory held on with small gold pins, ten total. 2 in the first and last sections and 6 in the middle section. is there any tricks to working with mother of pearl that will make my life easyer. ill post my progress, i thought it was high time i did a high end peace.
that i have. the handle area is going to be devided into 3 sections by leaving rased spacers. each spacer, butt and guard is going to be inlayed with mother of pearl. the scales will be elephant ivory held on with small gold pins, ten total. 2 in the first and last sections and 6 in the middle section. is there any tricks to working with mother of pearl that will make my life easyer. ill post my progress, i thought it was high time i did a high end peace.