Foiled Again!

[jhiggins]

HA HA!

Anyone know a cheap source of stainless foil?

 

[Mark Williams]

Steal it from the stainless foil store.

 

[Mark Williams]

Dont tell me your going over to the dark side with that nasty (gulp) STAINLESS

 

[jhiggins]

Dont tell me your going over to the dark side with that nasty (gulp) STAINLESS

Only halfway...

Actually breaking down and buying a heat treating oven next week I think, hence the foil.

 

[indian george]

Steal it from the stainless foil store.

BOY!! I wish I had said that foiled again.

 

[indian george]

Only halfway...

Actually breaking down and buying a heat treating oven next week I think, hence the foil.

Someone told me that you go Both Ways.

 

[rlinger]

Lost another customer to EvenHeat!

Jeff, I get mine from Enco. Check it out at www.use-enco.com

I think it is something like 75 to 80 bucks for 24 inches wide by 50 foot long roll. It is the 2000 F foil. They also sell the high temp stuff for more bucks. If you are not going to do a lot of stuff like BG-42 and S90V the 2000 F foil is all you need. I have done both BG-42 and S90V with it with no problem but if I end up doing a lot of that high temp steel I'll get the high temp foil.

If you find a better source than Enco please let all us know here.

RL

 

[jhiggins]

Lost another customer to EvenHeat!

RL

No so, Rog... PARAGON ALL THE WAY, BABY!

 

[rlinger]

That should be a great oven for you. I have seen many good reports about them here. I have seen not so good reports too but most have been good. I use Even Heat front load and want to go vertical also when I am financially able.

RL

 

[Kit Carson]

Go with Enco. Been using it for years and never had a problem with it.
Paragon is a good choice.

 

[jhiggins]

Thanks Roger, and Kit. I'll give the Enco a try.