Made this for a lightweight edc skinner. I used G10 for the frame to keep the knife strong, slender and light. Wood is some nice stabilized spalted curly maple. It's scary sharp with a polished convex edge. Had to take the pictures inside, don't laugh at my professional light box. Here are the specs:
Construction= Frame Built, tang is .450 wide at ricasso and runs back to the last set of handle pins.
Steel- Damascus- 52100-5160- 203E- and 15N20 X .140 =416 layers
AOL- 7 7/8 inches
HT- In house
Grind- Flat with drawn swedge
Finish- Hand sanded to 2000 grit and etched
Blade- 3 3/8 inches
Handle- 4 1/2 inches
Wood- Stabilzed Spalted Curly blackline maple
Hardware- 416 stainless pins and brass
Sheath- RH pouch style using handsewn vegetable tanned leather. Fully tooled front with plain back it is triple welted.
Asking 210.00 shipped in the USA or Canada
Paypal, USPS M/O, or cerified check preferred.
Questions or comments welcomed
Thanks for looking
Construction= Frame Built, tang is .450 wide at ricasso and runs back to the last set of handle pins.
Steel- Damascus- 52100-5160- 203E- and 15N20 X .140 =416 layers
AOL- 7 7/8 inches
HT- In house
Grind- Flat with drawn swedge
Finish- Hand sanded to 2000 grit and etched
Blade- 3 3/8 inches
Handle- 4 1/2 inches
Wood- Stabilzed Spalted Curly blackline maple
Hardware- 416 stainless pins and brass
Sheath- RH pouch style using handsewn vegetable tanned leather. Fully tooled front with plain back it is triple welted.
Asking 210.00 shipped in the USA or Canada
Paypal, USPS M/O, or cerified check preferred.
Questions or comments welcomed
Thanks for looking
Last edited:
