Hey Everyone - I've got a bit of a "time to recharge the bank account after Christmas" sale going on a couple of my AA Forge blades for you.
First up is the Grunt - This one has been very lightly used (some hairline scratches, slight surface oxidation from being stored/held), but still has the factory edge which is very sharp. Also includes a custom Badger Claw clip sheath that I had made for it when I originally purchased it. Retention is really good, and the clip is very strong.
The specs are as follows:
Overall Length: 8-1/8"
Blade Length: 3-1/2"
Blade Steel: 52100, 1/8" stock
Handle Material: Kevlar Micarta w/ Red Liners
Profile: Saber Flat Grind
Asking $155 shipped for the pair (USPS Priority, CONUS only).
Next up is the Woodsman. I got it last summer and have never actually used it, it's been a safe queen the entire time (might have some light surface oxidation from being held). I'm including a leather sheath with a dangler setup with it, but the sheath is intended for a Mora. The retention is ok, but it's really just a nice stand in until you get a custom one.
The specs are as follows:
Overall Length: 9"
Blade Length: 4-1/4"
Blade Steel: 52100, 1/8" stock
Handle Material: Tan Canvas Micarta Scale w/ Green Pinstripe Liners between Brown 1/8" Micarta Liner (see picture below)
Profile: Scandivex
Asking $old shipped on this one (USPS Priority, CONUS only).
If you have any questions about either setup, don't hesitate to PM me or email me at sno1983 AT gmail DOT com.
Thanks for looking!
First up is the Grunt - This one has been very lightly used (some hairline scratches, slight surface oxidation from being stored/held), but still has the factory edge which is very sharp. Also includes a custom Badger Claw clip sheath that I had made for it when I originally purchased it. Retention is really good, and the clip is very strong.
The specs are as follows:
Overall Length: 8-1/8"
Blade Length: 3-1/2"
Blade Steel: 52100, 1/8" stock
Handle Material: Kevlar Micarta w/ Red Liners
Profile: Saber Flat Grind
Asking $155 shipped for the pair (USPS Priority, CONUS only).
Next up is the Woodsman. I got it last summer and have never actually used it, it's been a safe queen the entire time (might have some light surface oxidation from being held). I'm including a leather sheath with a dangler setup with it, but the sheath is intended for a Mora. The retention is ok, but it's really just a nice stand in until you get a custom one.
The specs are as follows:
Overall Length: 9"
Blade Length: 4-1/4"
Blade Steel: 52100, 1/8" stock
Handle Material: Tan Canvas Micarta Scale w/ Green Pinstripe Liners between Brown 1/8" Micarta Liner (see picture below)
Profile: Scandivex
Asking $old shipped on this one (USPS Priority, CONUS only).
If you have any questions about either setup, don't hesitate to PM me or email me at sno1983 AT gmail DOT com.
Thanks for looking!
Last edited:
