Hi guys,
Time for me to pass this one along. Got this in a trade a some time ago, I've carried it and used it some. This is a nice sized edc.
I dont really know much about this knife or the maker. I know the maker goes by the username Gull Wing and I've seen some of his work on other forums and I know he is an active member on several forums, thats about all I know on the maker.
The knife appears to be CF handles obviously, I believe the blade is 440C. It is marked w/ the makers logo on one side and reads 45RD08.4C on the opposite side. I believe the pc is Ti, I'm unsure of the liner material but I think it might be Ti. The knife has a Spyderco compression lock which I believe was used with permission. A very nice little folder. There are some light carry marks on the pocket clip.
I cleaned up the grinds a little and then beadblasted the blade. I didnt blast the tang of the blade, only the primary grind area as I didnt want to cover up the original makers marks. I left the spine of the blade w/ a satin finish.
BL: 2 /3/4" w/ 2 1/2" cutting edge
Asking****150.00**** shipped in the Cont. U.S. Priority w/ DC #.
Will consider trades for knife making materials/equipment.
Please pm any questions.
Thanks for looking
Time for me to pass this one along. Got this in a trade a some time ago, I've carried it and used it some. This is a nice sized edc.
I dont really know much about this knife or the maker. I know the maker goes by the username Gull Wing and I've seen some of his work on other forums and I know he is an active member on several forums, thats about all I know on the maker.
The knife appears to be CF handles obviously, I believe the blade is 440C. It is marked w/ the makers logo on one side and reads 45RD08.4C on the opposite side. I believe the pc is Ti, I'm unsure of the liner material but I think it might be Ti. The knife has a Spyderco compression lock which I believe was used with permission. A very nice little folder. There are some light carry marks on the pocket clip.
I cleaned up the grinds a little and then beadblasted the blade. I didnt blast the tang of the blade, only the primary grind area as I didnt want to cover up the original makers marks. I left the spine of the blade w/ a satin finish.
BL: 2 /3/4" w/ 2 1/2" cutting edge
Asking****150.00**** shipped in the Cont. U.S. Priority w/ DC #.
Will consider trades for knife making materials/equipment.
Please pm any questions.
Thanks for looking
