FS: EDC/Skinner - Jeans with Ostrich!

navman

navman

Knifemaker / Craftsman / Service Provider
Feedback: +36 / =0 / -0
Joined
Mar 4, 2013
Messages
2,873
This Boot Skinner has "jeans" scales (blue linen and natural linen micarta) with copper hardware and a stainless/CF Trinity decorative pin. The lanyard tube is surrounded by natural micarta. Ground from 1/8" thick CPM S90V on a 24" radius platen and hand satin finished Heat treat by Peters' to 61.5 HRC. BTE thickness is .008 (geometry cuts)! Tapered tang (.020") with a 3.25" blade, 7.5" OAL. Spine is rounded and has a short section of 30LPI thumb serrations. As I mentioned in the CPM thread, I am now marking my CPM S90V with the steel type to differentiate between any new material that I may use in the future.

I am very happy with the belt sheath. It is hand stitched in brown leather with a blue ostrich leg inlay and blue stitching to compliment the knife.

Price is $300 NOW $290, shipped CONUS.

WTrJlO4.jpeg

j9Xxw5h.jpeg

u00ir0u.jpeg

RMUgfNF.jpeg

br9bepl.jpeg

kr10sDe.jpeg
 
Last edited:
This is still available. Gonna go ahead and drop the price a bit. $290 shipped.
 
Had some interest from a local dude, but no comms for over a week, so this one is still available.
 
Still available. If interested, I will make a pocket/boot clip sheath at no additional charge ($75 value if bought separately).
 
Beautiful knife & sheath. So very tempting, but I'm stretched too thin right now. Just bad timing for me. 😖
 
You must log in or register to reply here.
Back
Top