Hey guys, selling my Hanko Ti Twisted Trident (Mark III). It comes with the SteelFlame Silver Crusader Pocket Clip and also includes the original SF HMW stamped clip.
Also included on this sale are 4pcs AW IMR 18350 and a Nitecore D2 charger. There are a few fine scratches on the tail end and some very small ones on the head due to normal everyday carry.
The following are specifications I grabbed from HMW:
***MkIII - Mid March 2016, Switch to Nichia 219C***
- Titanium Body, Bezel and (Steel Flame) Pocket Clip.
- Made of grade 5 titanium with stonewash finish. (Other metals available)
- Ti Stamped Pocket Clip by Steel Flame. (T10 fastener)
- Triple (3) Neutral tint (~5000K) Nichia 219C LED's.
- Narrow spot frosted optic for evenly diffused beam without artifacts.
- Requires IMR 18350 cell. Does NOT use CR123.
- 3 amp driver with Guppydrv firmware. 22 user selectable groups. Something for everyone with no complicated programming required. All lights are shipped with user group 11 loaded.
- The entire LED/Noctigon copper PCB/copper heat sink assembly is all reflow soldered at the same time using silver solder. No thermal adhesives or compounds of any kind used anywhere. The result is unmatched thermal transfer and reliability for reliable, long life.
Asking is: SOLD (PP Goods & Services only). Includes fully insured shipping (It will either be USPS Priority or FedEx Express Saver / depends on location).
CONUS sales only and no forwarding addresses (unless I personally know the buyer).
Photos to follow***
Also included on this sale are 4pcs AW IMR 18350 and a Nitecore D2 charger. There are a few fine scratches on the tail end and some very small ones on the head due to normal everyday carry.
The following are specifications I grabbed from HMW:
***MkIII - Mid March 2016, Switch to Nichia 219C***
- Titanium Body, Bezel and (Steel Flame) Pocket Clip.
- Made of grade 5 titanium with stonewash finish. (Other metals available)
- Ti Stamped Pocket Clip by Steel Flame. (T10 fastener)
- Triple (3) Neutral tint (~5000K) Nichia 219C LED's.
- Narrow spot frosted optic for evenly diffused beam without artifacts.
- Requires IMR 18350 cell. Does NOT use CR123.
- 3 amp driver with Guppydrv firmware. 22 user selectable groups. Something for everyone with no complicated programming required. All lights are shipped with user group 11 loaded.
- The entire LED/Noctigon copper PCB/copper heat sink assembly is all reflow soldered at the same time using silver solder. No thermal adhesives or compounds of any kind used anywhere. The result is unmatched thermal transfer and reliability for reliable, long life.
Asking is: SOLD (PP Goods & Services only). Includes fully insured shipping (It will either be USPS Priority or FedEx Express Saver / depends on location).
CONUS sales only and no forwarding addresses (unless I personally know the buyer).
Photos to follow***
Last edited: