1.Looking to put an order in for a blue one, so going to try to sell this one first.
WC CQB black AT built end of 2014. Stainless hammer and med. solid trigger. Ringed plug. No FCS. Naked slide. Cocobolo starburst flat bottom. BP Magwell. Gold bead front. Battle rear. Flat wire spring upgrade.Flush cut reverse crown barrel.
50 flawless rounds through this one, then back in the safe. Comes with everything that came from WC.
$3SOLD shipped to your FFL. USPS money order. Not looking for trades.
2. I have a stainless EB 38 super. Mint. 25 rounds fired through. Flawless! Harrison grips, original included also. front sight is black serrated. Everything included from EB. I had the following work done by Alchemy:
Fit and Blend EB C.L. III Maxi Well
Serrate Back of Slide,
30 Degree F/C & Polished Crown
Install Medium, Solid Trigger
Install Ed Brown Extended Mag Release
Fit Extra Extractor, Tune, Blend, Polish, & Serrate
Install Oversized C&S hammer and sear pin set
Fit EGW O.S. Firing Pin Stop/hand radius to match original
Presentation Grade Bead Blast re-finish on all needed parts
Refinish both extractors post serration
Polish Feed Ramp
Asking $3000 shipped to your FFL. USPS Money order. No trades.
WC CQB black AT built end of 2014. Stainless hammer and med. solid trigger. Ringed plug. No FCS. Naked slide. Cocobolo starburst flat bottom. BP Magwell. Gold bead front. Battle rear. Flat wire spring upgrade.Flush cut reverse crown barrel.
50 flawless rounds through this one, then back in the safe. Comes with everything that came from WC.
$3SOLD shipped to your FFL. USPS money order. Not looking for trades.
2. I have a stainless EB 38 super. Mint. 25 rounds fired through. Flawless! Harrison grips, original included also. front sight is black serrated. Everything included from EB. I had the following work done by Alchemy:
Fit and Blend EB C.L. III Maxi Well
Serrate Back of Slide,
30 Degree F/C & Polished Crown
Install Medium, Solid Trigger
Install Ed Brown Extended Mag Release
Fit Extra Extractor, Tune, Blend, Polish, & Serrate
Install Oversized C&S hammer and sear pin set
Fit EGW O.S. Firing Pin Stop/hand radius to match original
Presentation Grade Bead Blast re-finish on all needed parts
Refinish both extractors post serration
Polish Feed Ramp
Asking $3000 shipped to your FFL. USPS Money order. No trades.
Last edited: