FSOT HORTON Tac4 cf with Mayo holes

Status
Not open for further replies.
Feedback: +17 / =0 / -0
Joined
Sep 15, 2010
Messages
235
With a heavy heart its time to let this amazing piece go. It's been in my pocket since I got it and used it sparingly but nothing crazy. It is super sharp, solid, smooth and functionally sound. Jeremy knows how to make a knife and I have a feeling I'm going to regret letting this go. Per Jeremy this is a 1st gen.

FULL DISCLOSURE: I want to make sure the new owner is fully aware of the condition of the knife so there are no issues or misconceptions when they receive it. First there is a mark on the clip and lock side from pocket carry which is how I initially received it. When I carried the knife it was just put into my pocket. Secondly there is a slight burr or nick in the blade near the tip. This was also how I received it. You can feel it with your finger nail but it does not negatively impact the cutting performance at all. I have tested it numerous times and didn't have any issues with it catching. I did strop the knife occasionally which I think helped even out the edge. Lastly which is a minor issue but I think adds a little bit of uniqueness to the knife, the thumb hole wasn't perfectly ground out. It's nitpicking but my OCD did catch that immediately LOL. I tried to capture the "flaws" the best I could in the pics below.

I'm letting this go for less then what I have into it $1750>1700>1675>$1575 obo Paypal only shipped priority mail to the US50+. Price includes all fees. Unfortunately I will not be shipping this one internationally. Just an fyi before I get accused of any "Brape" I didn't buy this directly and the price is set for lower than what I traded into it.

If you have any questions for me please do not hesitate to reach out to me. I do want to point out that I will be leaving for vacation from 06/05 - 06/12 so I would like to get this out before I leave.

Thank you for your time!

Hope you all have a blessed day,
Jason


a4a5aved.jpg

zyqatuny.jpg

e7uhavu7.jpg

ny8enajy.jpg

e4eqa2em.jpg

nuvuryqa.jpg

e4a5u2u7.jpg

yny6yqer.jpg
 
Last edited:
I've been asked for better pics of the nick in the blade. To clarify its extremely small and difficult to take pics of. The nick itself seems to only be on the platinum side and not on the flat chisel side.

Below the nick or burr is the little sparkle. I had to make it glimmer to show where it is

by3esy7y.jpg
 
Feel free to make me a reasonable offer. I'd like to get this out tomorrow morning before I leave for vacation.
 
Status
Not open for further replies.
Back
Top