Great!!! little edc in ironwood (sold)

A

Alan Warren Knives

Feedback: +62 / =0 / -0
Joined
Dec 31, 2009
Messages
2,630
Hello to All. Here I have just finished another small edc. Over the years I have accumulated quite a lot of small pieces of wood that are too small to be used on the larger knives so lately I have been making some small size knives so I can utilize some of these small pieces. I have many customers that love this size knife. It can be used for bnt, edc, or caping. Hope you like it.

Blade is ATS-34 .094 thick and 2.45 from tip to bolsters. O/A is 5.875 in. Tang has been tapered and the tricky part of tapering this small blade is not tapering your finger at the same time. Blade has been polished and hand rubbed to 1200 grit. I ground the blade to .012 and .025 at the tip. VERY!! SHARP!! It has been heat treated by me with cryo and double tempered for two hrs ea. time. RC is 60-61.

Bolsters are carbon fiber held tight with bronze welding rod.

Handle is of ironwood with mosaic pins and lanyard hole.

Sheath will be custom made to fit the knife and can be made left or right as specified. Included with deal.

Asking (sold) shipped conus and I accept paypal. Thank you for looking Alan
 
Last edited:
awesome. in the past few months i bought a 2.5in fixed blade from another maker and i am extremely satisfied with that size. i wish i could justify purchasing this as i know it would end up in my pocket every other day.
 
T.L. said:
awesome. in the past few months i bought a 2.5in fixed blade from another maker and i am extremely satisfied with that size. i wish i could justify purchasing this as i know it would end up in my pocket every other day.
Click to expand...

Thank you sir, It is a fantastic little knife and of course weighs nothing.
 
You must log in or register to reply here.
Back
Top