- Joined
- Nov 13, 2004
- Messages
- 650
Nice job! I think I'll give it a go with grooves like Rick posted.
Doberman_Dave
formerly tlmzdac
Doberman_Dave
formerly tlmzdac
-
The BladeForums.com 2024 Traditional Knife is available! Price is $250 ea (shipped within CONUS).
Order here: https://www.bladeforums.com/help/2024-traditional/
Groove Warden Revisited
- Thread starter MD13
- Start date
- Joined
- May 25, 2005
- Messages
- 2,362
Gatorginzo- I just threw them in there for now. I wasn't even thingking about lining them up. Maybe I'll give it a whirl. 
Randucci- If I could find the right thickness of brass tubing, brass rivets would be ideal. That's probably what I'll end up doing. I have a post bookmarked about someone else here that replaced the rivets on one of their Busses. I think brass rivets would look sweet!
Jeepnut- I just used a step bit to drill out one side of the rivets, then just used a punch to drive the remaining side out. It was pretty easy actually. :thumbup:
-Dan
Randucci- If I could find the right thickness of brass tubing, brass rivets would be ideal. That's probably what I'll end up doing. I have a post bookmarked about someone else here that replaced the rivets on one of their Busses. I think brass rivets would look sweet!
Jeepnut- I just used a step bit to drill out one side of the rivets, then just used a punch to drive the remaining side out. It was pretty easy actually. :thumbup:
-Dan