Half Life X

[tryppyr]

That's a wicked looking blade! If I ever get my throat cut that would be the tool to use.

 

[Rossi Knives]

That's a wicked looking blade! If I ever get my throat cut that would be the tool to use.

Thanks,

Hopefully it won't come to that.

 

[Alarion]

"Half Life X" is glow-in-the-dark handle material. I just saw it at Knifekits.com http://www.knifekits.com/vcom/product_info.php?cPath=40_218_362&products_id=1982It looks pretty cool, but I have never seen it in real-life before.

Ohforgossake!!! There's no limit to bad taste? :foot:

 

[Bhamster]

You might want to check out glowinc.com. They have active forums etc concerning this st6uff and all sorts of tables, charts and info and they sell it of course. I bought some to do my daughters ceiling with a star pattern with their brightest green glow powder. It really is very bright and for about 20 bucks I did her whole ceiling with stars, galaxies etc. Once the lights go out it glows brightly for quite a few hours and is still barely visible as glowing in the morning. Gives the kiddos something to stare at while they are fading out.

 

[schmiddy]

I mixed 1/8th teaspoon glow powder with 5ML of "flex coat lite" rod building epoxy. The hardest part was getting the particulates not to settle to the bottom. After the epoxie started to set up slightly it got easier to get the particulates suspended in the epoxy. I realized I didn't get very many particulates into the grooves as I would like so I had to wipe it off and start again. This caused the particles to be spread all over the place. Once it dried this morning I was able to sand the handle leaving only the grooves left with epoxy and looking great.

Pictures last night before I sanded.