Lot of ball peen hammer heads and a few other kinds. Most are vintage, and a few have already been annealed. I had been saving these to make tomahawks but I'm never going to get around to it. Looking for $SOLD for all, shipped in the US, Paypal F&F
Surface Grinder Attachment with 1.5" tooling arm; will fit KMG, Northridge, etc. It was made by a forum member and works quite well, I just have little use for one. Magnet is 2.5" x 12" and can handle blade thickness up to 3/8". Wheels are 3" wide, and both smooth and serrated wheels are included. Unit runs on 4 roller bearings and is very smooth. $SOLD shipped Paypal F&F
9" Disc for a disc grinder with 1 degree bevel from USA Knife Maker. Disc has never been used but does have some marks from storage. Rubber for making a rubber backing is included, as well as the set screw for attaching to keyed 5/8" motor shaft. $SOLD shipped Paypal F&F
Surface Grinder Attachment with 1.5" tooling arm; will fit KMG, Northridge, etc. It was made by a forum member and works quite well, I just have little use for one. Magnet is 2.5" x 12" and can handle blade thickness up to 3/8". Wheels are 3" wide, and both smooth and serrated wheels are included. Unit runs on 4 roller bearings and is very smooth. $SOLD shipped Paypal F&F
9" Disc for a disc grinder with 1 degree bevel from USA Knife Maker. Disc has never been used but does have some marks from storage. Rubber for making a rubber backing is included, as well as the set screw for attaching to keyed 5/8" motor shaft. $SOLD shipped Paypal F&F
Last edited:
