Pic taken straight from the top, looks equal lenghth on both side. And lock up at the same place on both side.
The small cut, again circled in red.
-
The BladeForums.com 2024 Traditional Knife is ready to order! See this thread for details: https://www.bladeforums.com/threads/bladeforums-2024-traditional-knife.2003187/
Price is$300$250 ea (shipped within CONUS). If you live outside the US, I will contact you after your order for extra shipping charges.
Order here: https://www.bladeforums.com/help/2024-traditional/ - Order as many as you like, we have plenty.
Has anyone seen this on their umnanzaan?
- Thread starter lai77120
- Start date
The small cut, again circled in red.
Some pictures please😆
- Joined
- May 7, 2012
- Messages
- 4,971
I have a crappy iphone 5. I can't get pics, but they are visible on the 1-2 o'clock position.
I'm not at all surprised at this. The thumb studs and stop pin are interference fit. IIRC the Sebenza thumb stud hole uses a Go/No-Go gauge @ .155" & .157" so 2 thousands of an inch difference. They would probably prefer to have a little give in the thumb stud itself to prevent splitting blades.
Last edited:
- Joined
- May 7, 2012
- Messages
- 4,971
Does anyone else think that it looks llike the lug has somewhat pulled out of the blade? Notice the shiny ring around the circumference of the lug. If the ring were flush with the blade, the indentation would not be visible.
IMO the pin is slightly offset to the left, but not enough to hide that indentation. It's hard to tell with the way the lens works. Need to see it with the eye.
That "shiny ring" part is visible on the other (right) side as well..Does anyone else think that it looks llike the lug has somewhat pulled out of the blade? Notice the shiny ring around the circumference of the lug. If the ring were flush with the blade, the indentation would not be visible.
Ha ha😆 I hope you are not trolling me here, but I expected this. Taking photos (hand held with a cellphone) of a relatively small object like a knife, even the slightest movement will greatly affect the perspectives of the subject, so I took a ruler to it... It measured the same 6mm (from tip of the dome to the base)on both side. Then again the difference might be too small to measure with a common ruler.If I may, and due to late night boredom, I'd like to present Exhibit "B". In the provided photo, the lug on the left side appears to protrude further out than the opposite side.
Maybe someone went a little overboard with the relief cut on mine and left a larger than necessary mark on it. (maybe Chris himself did it! That'll just be awesome 😆
No need to get upset, I was just kidding. All your inputs are greatly appreciated 👍