Has Noss ever tested AUS 8?

[psy-ops]

If so, how did it perform?

Thanks

 

[Phil Elmore]

I imagine it broke when he hammered it through a cinder block. Must suck as steels go.

 

[Kiah]

If so, how did it perform?

Thanks

No.

I imagine it broke when he hammered it through a cinder block. Must suck as steels go.

You know you could at least wait till someone answers a simple question before you start trolling.

 

[bluejaunte]

I wasn't aware it was possible to troll a thread that was, itself, a troll.

 

[Liam Ryan]

Some people have a lot of practice.

 

[SPXTrader]

A mighty hand is going to smote all of you...


And I'll bet it was a bad heat treat.

 

[Kiah]

I wasn't aware it was possible to troll a thread that was, itself, a troll.

Because psy-ops has a history of trolling the forums trying to encite arguments?

A mighty hand is going to smote all of you...


And I'll bet it was a bad heat treat.

Could be. I figure it's more likely an inclusion that leads to a massive blowout under heavy use.

 

[Liam Ryan]

Hold on, isn't it all forged in Australia?
Everyone knows they use wooden mallets there, Noss should pound it with a wooden mallet.

 

[Esav Benyamin]

Gentlemen, this is Knife Reviews & Testing, a serious discussion forum. If you don't feel the original topic meets your exalted standards, go read something else. Whine & Cheesing it to death is discourteous at the least, which is wrong.

I am locking this, to allow the original poster to try again without these distractions.