Help!!!! I need a Quick, Inexpensive, Quality Custom Maker

Joe, the cant is small, but I will look at that, thanks for pointing that out. I may just reduce the rear expansion.

Jerry, I will own a Magnum Camp Knife, I always kicked myself for not getting one, as you probably read in the Camillus Forum. But what is the handle to be made of?

I should have my Martial Kitchen Knife scanned by Friday to get your thoughts. And to get it to makers to get the ball rolling.

MDP
 
MDP, You asked for a Quick, Inexpensive, Quality maker. The old adage is that you can have any two of the three traits listed above but not all three!

Bruce Woodbury
 
At the Bayfield Art Knife show, Brian Lyttle brought out a wonderful kitchen knife that he used to carve the Pig at this annual affair and this knife was checked out for sharpness. Brian has spent much of his time these past few years while recovering from a variety of accidents with horses to improve his knowledge of heat treating and edge geometry.

Kevin Cashen tested this knife and was able to cleanly slice thru 5 falling sheets of standard paper. ATS34.

Talk to him about Talonite but also listen to what he has to say about what he is currently doing in knifemaking.

More info can be obtained by pointing to the BAKCA site for knifemakers information
http://www.cgcweb.com/bakca/cstmaker/mkrsearch.html

 
You must log in or register to reply here.
Back
Top