KnuckleDownKnives
Time to make the doughnuts..
- Joined
- Feb 12, 2015
- Messages
- 1,715
Hey all. Need some help identifying this motor and if I can run it on single phase 220v
Thanks.
Thanks.
-
The BladeForums.com 2024 Traditional Knife is available! Price is $250 ea (shipped within CONUS).
Order here: https://www.bladeforums.com/help/2024-traditional/
Help with motor
- Thread starter KnuckleDownKnives
- Start date
- Joined
- Oct 17, 2007
- Messages
- 4,302
That's a 3 phase motor. You'll need a VFD or a phase converter to run it.
Alan Davis Knives
Knife Maker
- Joined
- Jun 28, 2010
- Messages
- 2,249
It is a 3 phase motor, you will need a vfd or other means to convert 1 phase to 3 phase.
KnuckleDownKnives
Time to make the doughnuts..
- Joined
- Feb 12, 2015
- Messages
- 1,715
Thaaaaats what I figured. It does work at least. Got it to spin up once I flipped the high low volt thing inside it, but the thermal protection kicked in after about 30 seconds. Well I'll put it on the shelf and save it for another project. Got the other motor working once I swapped the blower pulley over to a 12" I got off the biro meat saw I've been salvaging parts off of. Had to use the bigger pulley as the other motor I have is 3450 rpm and only 1/2 hp. Just need to make a new pigtail and the stand.