This is an update on our Engraved Hinderer Half Tracks. We originally stated that these were done by Laser. We found out while visiting Hinderer this past weekend that this was not the case. These full ti Half Tracks had the graphic CNC machined on the presentation side. This leaves a stunning very deep engraved knife. This is something rarely done by Hinderer. Check these and more out at:
http://www.usamadeblade.com/Half-Tracks_c84.htm

Thank you for looking!
Scott (Whitty) Whittington
scott@usamadeblade.com
http://www.usamadeblade.com/Half-Tracks_c84.htm

Thank you for looking!
Scott (Whitty) Whittington
scott@usamadeblade.com