Hinderer XM18 screw size

[corwise]

I have a Hinderer XM-18 I bought in 2008. At some point I had reversed the clip and didn't tighten the screws well enough, so they're now lose. Rob was nice enough to send me some replacement screws, but I can't get the old screws out. They're hex, unlike the nice new phillips, and I can't find a hex size that will fit in them (very tiny). Anyone know the hex size they use so I can pick one up? Thanks.

 

[Grandmaster]

If youre not planning on using them use a dremel tu cut a line across the screw and easily take them out with a flat head, you can get those screws for free so I would not worry about cutting two

 

[Ratman79]

i know the gen 4's use a 5/64th hex driver....(i am unsure if earlier gens use the same size)

 

[Boru13]

The hex size for the clips screws would be 0.050".

 

[corwise]

Thanks Boru!