Horton Knives,,Presents..CLUB PLATINUM...

Status
Not open for further replies.
So time to start a tshirt thread? Just a sort of pre-order one to gauge interest and get peoples sizes? Given enough interest here in the next page or two i'll start one tomorrow if someone else doesn't beat me to it.

I'm in for 1 or 2. Maybe a 'Firepower Through Superior Edge Geometry' run and a 'CLUB PLATINUM' run?
 
RoyalM said:
So time to start a tshirt thread? Just a sort of pre-order one to gauge interest and get peoples sizes? Given enough interest here in the next page or two i'll start one tomorrow if someone else doesn't beat me to it.

I'm in for 1 or 2. Maybe a 'Firepower Through Superior Edge Geometry' run and a 'CLUB PLATINUM' run?
Click to expand...
There you go, sounds good. :thumbup:
 
Just did some back reading through the last few pages, can't believe anyone gives you shit for grinding a few blades at work especially co-workers. Jealousy is all I can think of as to their motives.

I'm in a similar (but vastly scaled down) situation at work just now. I 'drop of the radar' for a couple of hours a day to grind on some 01 turning it into vaguely knife shaped objects. Only got an angle grinder and a small belt sander so takes me a while to do a knife. I'm mostly making them for fellow marines and sell them to the guys at cost. I don't charge for my time as the Corp is paying for that. Helps me improve my grinding skills and gives the lads a chance at a one off knife. No one has grumbled at me yet, maybe i'm lucky enough to work with decent and supportive guys?

That was some nice machinery in your vids J, and those blades make my ASH-1 look down right anorexic!
 
OkudenandHinderer001.jpg


OkudenandHinderer002.jpg


OkudenandHinderer005.jpg


OkudenandHinderer004.jpg


OkudenandHinderer007.jpg


OkudenandHinderer008.jpg
 
Since I got confermation on my Buddy Mikkel making me a custom,, the Hinderer may have to go,, unless she grows on me,,
 
RoyalM said:
So time to start a tshirt thread? Just a sort of pre-order one to gauge interest and get peoples sizes? Given enough interest here in the next page or two i'll start one tomorrow if someone else doesn't beat me to it.

I'm in for 1 or 2. Maybe a 'Firepower Through Superior Edge Geometry' run and a 'CLUB PLATINUM' run?
Click to expand...

I'd be in. For 2.
 
I just got a waterbill for $207.00 because of my wifes flower beds.:grumpy: Jeremy if you will send me a proto I will gladly see how many cuts I can make on 300ft of water hose.:mad: Should be a nice test!!!!
 
chickenplucker said:
I just got a waterbill for $207.00 because of my wifes flower beds.:grumpy: Jeremy if you will send me a proto I will gladly see how many cuts I can make on 300ft of water hose.:mad: Should be a nice test!!!!
Click to expand...
:D lol



Well look at that J. Looks like the first TS-1 run sold out, before they were finished. Nice! :thumbup::thumbup:
 
Status
Not open for further replies.
Back
Top