How to center slipjoint blades?

[wkfl]

Was it this video? I was tooling around utube and entered crinking. Fixing to try it on one of my many ghosts in the drawers. Thanks

 

[Signalprick]

Yea, I think so. I thought there was another one similar where the maker explains what and how to do it but that looks familiar. Big thing here is just make sure you dont grind your pins flush until your absolutely ready. Dont want to whack too awful hard either for obvious reasons. But the technique is definitely a tool for the proverbial knife maker toolbox.

 

[Natlek]

Basically I drill the pivot hole on the mill with a 43 drill, followed with the 3/32 reamer then HT. I could not say if it’s perpendicular tho.

If you have 1-2-3 block you can easy check that .........just find end mill bits or drill bits which will fit tight in 1-2-3 block holes .................