Jack O'Neill
Gold Member
- Joined
- Nov 15, 2007
- Messages
- 7,193
Hello all ,I recently finished up this nice little hunter/skinner in D-2 tool steel , time to offer it up .
Full height flat grind nice and thin from 1/8" D-2 tool steel bar stock , heat treated to an Rc. 61-62 with the sub-zero quench . It has a fine scotch-brite belt finish .
The overall length is 8-1/4" , blade is 3-1/2" and 1-3/8' wide .
Lots of eyes in the stabilized Buckeye Burl handle , red liners , a center copper Corby bolt and 2 mosaic pins .
Sheath is right hand carry .
$185.00 shipped in the USA or Canada , others please write for actual ship cost . Pay-pal , postal m/o , or check ( held to clear ) . My PP is sandlot@charter.net .
Hope you all like it and thanks for looking .
Jack
Full height flat grind nice and thin from 1/8" D-2 tool steel bar stock , heat treated to an Rc. 61-62 with the sub-zero quench . It has a fine scotch-brite belt finish .
The overall length is 8-1/4" , blade is 3-1/2" and 1-3/8' wide .
Lots of eyes in the stabilized Buckeye Burl handle , red liners , a center copper Corby bolt and 2 mosaic pins .
Sheath is right hand carry .
$185.00 shipped in the USA or Canada , others please write for actual ship cost . Pay-pal , postal m/o , or check ( held to clear ) . My PP is sandlot@charter.net .
Hope you all like it and thanks for looking .
Jack
