The blade is about 5-1/2" long, 1"wide and 3/16" thick at the bolster. Hand forged from the A2 tool steel round stock close to the final shape. Heat treated to 59-60HRC. It has a nice taper to the tip. Flat ground and hand finished to 800 grit.
The bolster is a sculpted piece of deer antler. The handle is made of exhibition grade curly maple. A lot of marbeling and figure.
The handle is vacuum treated and polished with carnauba wax.
This knife comes with the fitted leater sheath.
I am asking Reduced to $250for it, shipped CONUS via USPS Priority Insured Mail.
PayPal preferred. Will take the Personal Check(ship after the check is cleared)
Thank you!
The bolster is a sculpted piece of deer antler. The handle is made of exhibition grade curly maple. A lot of marbeling and figure.
The handle is vacuum treated and polished with carnauba wax.
This knife comes with the fitted leater sheath.
I am asking Reduced to $250for it, shipped CONUS via USPS Priority Insured Mail.
PayPal preferred. Will take the Personal Check(ship after the check is cleared)
Thank you!
Last edited:
